Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterHow Much Does Gate Repair Cost in Dallas?
Gate repair in Dallas typically runs $185 to $650, with most single-gate fixes landing near $310. That covers the common jobs we see across the city: a sagging driveway gate that drags on the concrete, a latch that stopped catching, a keypad that quit talking to the opener. Electric gate repair costs more, usually $260 to $1,400 depending on whether the problem lives in the motor, the control board, or the wiring buried under the yard.
Here’s what matters most: you’ll know your exact number in writing before we touch anything. No surprise line items, no “we found something else while we were in there.” Latch & Post Gate Repair in Fort Worth, TX has been part of the Cedarwell family of independently owned gate specialists since 2009, and the written price is standard on every visit, not a special favor.
Key Takeaways
- Most gate repairs in Dallas cost $185-$650.
- Electric gate and opener repairs run $260-$1,400.
- Replacing a bent gate or a rusted post often costs more than fixing it, and we’ll tell you which side you’re on before you spend a dollar.
- Free estimates, 365-Day Done Right Promise, and a live person answers the phone around the clock.
Gate Repair Cost Breakdown (2026)
These ranges reflect the Dallas market as of 2026, including labor and the parts we keep on the truck. If a job needs a factory-ordered motor or a custom-welded frame, that gets quoted separately and in writing.
| Repair type | Typical cost range | What it usually involves |
|---|---|---|
| Latch replacement or adjustment | $185 – $320 | New latch hardware, striker alignment, gate swing tuning |
| Hinge repair or replacement | $210 – $420 | Weld repair or bolt-on hinges, sag correction |
| Gate post repair | $280 – $700 | Re-seating a leaning post, concrete work, bracket reset |
| Gate opener repair (LiftMaster, Linear, Mighty Mule, Ghost Controls) | $260 – $780 | Gear, belt, chain, logic board, limit switch |
| Electric gate control board or sensor | $320 – $900 | Board swap, safety loop, photo-eye, keypad |
| Wiring and low-voltage diagnostics | $240 – $650 | Tracing a short or break in underground or conduit runs |
| Commercial swing/slide gate repair (FAAC, BFT, DoorKing, Elite, Viking) | $450 – $1,400 | Heavy operator service, loop replacement, access control |
| Full gate replacement (when repair isn’t the right call) | $1,600 – $6,500+ | New gate, posts, hardware; opener reused or replaced |
What pushes a job toward the top of its range? Rusted-through posts that need concrete work, gates wider than a standard 12-foot driveway, and anything requiring a factory-ordered part instead of what’s already on the truck. What pulls it down? Clean access, gate hardware that hasn’t been welded over three times by someone else, and a problem caught early. In Dallas, sun and shifting clay soil eat posts from the inside out, so the “small wobble” you notice in March is often a $300 repair that would have been an $1,800 replacement by August.
We work on the brands families here actually own: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Factory-trained on all nine, which means the right fix on the first visit instead of a parts guess.
What Affects Gate Repair Pricing in Dallas
- Gate material and weight. A cedar privacy gate behaves nothing like a wrought-iron one. Heavier gates need heavier hardware, and that hardware costs more – but it lasts longer, so we won’t put a light-duty hinge on a 200-pound gate just to hit a lower number.
- Swing or slide. Sliding gates have tracks, rollers, and often an underground stop. More moving parts means more diagnosis time, which is where a $220 latch job can turn into a $600 roller and track repair.
- Power or manual. Manual gates are simpler and cheaper to fix. Electric gates add a motor, a control board, safety sensors, and low-voltage wiring – that’s where the $260-$1,400 electric range comes from.
- Dallas soil and heat. Our black clay expands and contracts hard between dry summers and wet springs. Posts shift, gates rack out of square, and what worked in June misses the latch by November. We see this on nearly every older gate in Lakewood, where the trees and the soil both move the ground under the posts.
- Permits and HOA rules. The City of Dallas requires a permit for new gate and fence construction above certain heights, and many HOAs limit gate color, material, and height. Repairs generally don’t need a permit, but a full replacement might, and we’ll tell you which side of that line your job falls on.
- Access and buried lines. If the wiring runs under a poured patio or through conduit that’s been paved over, that’s a few more hours of careful work. We say so up front instead of halfway through.
How to Save on Gate Repair
The cheapest gate repair in Fresno, CA is the one you catch early. A hinge that’s just started to squeak is a $210 fix; the same hinge ignored for two years takes the post with it and turns into a $700 job. Walk your gate once a season – lift the free end, listen for grinding, check whether the latch still lands in the same spot. That two-minute check is free and it’s the single best thing you can do for your gate budget.
A few more ways to keep costs down:
- Fix the hardware before you replace the gate. Most gates that “need replacing” just need new hinges and a squared-up post.
- Bundle repairs. If the latch and the opener both need attention, catching them in one visit saves you a second trip charge.
- Keep the brand you have. If your LiftMaster opener is repairable, repairing it usually beats swapping to a different system and re-wiring everything.
- Ask for the written price. Ours always comes before work starts. If someone won’t put a number in writing, that’s your cue to call someone who will.
Free estimates are standard here. Call (626) 649-4572 and you’ll get a live person, day or night – no voicemail, no callback queue.
What a Latch & Post Visit Looks Like
- You call and a live person answers – 24 hours a day, 7 days a week. We ask what the gate is doing and which brand it is.
- We schedule a time that works around your family, including nap windows if quiet matters.
- A background-checked, uniformed technician arrives and walks the gate with you before touching anything – the “Ask before we move or touch anything” part of our Cedarwell C.A.R.E. values.
- You get a written price. Every line item, before any work begins.
- We do the repair, using pet-safe lubricants where there’s a choice. Inside the home, we lay drop cloths and put on shoe covers – your floors stay clean.
- We take a photo of the cleaned-up area before we leave, and send it to you. Both are included, never an upsell.
- Every repair is covered by the 365-Day Done Right Promise. If it isn’t right, we make it right – no argument, no fine print.
FAQs - Gate Repair Cost
How much does it cost to repair a gate in Dallas?
Most gate repairs in Dallas cost $185 to $650, with a typical job around $310. A latch replacement usually runs $185-$320; hinge work runs $210-$420. If the gate is electric, expect the range to stretch to $260-$1,400 depending on whether it’s the motor, the board, or the wiring. Call (626) 649-4572 for an exact quote – estimates are free.
Is it cheaper to repair a gate or replace it?
Repair is cheaper in almost every case where the gate frame and posts are still sound. A repair runs $185-$650; a full replacement starts around $1,600 and climbs past $6,500 for a wide, custom, or automated gate. The honest answer depends on the posts – if they’re rusted through, we’ll say so and show you. If they’re solid, a repair will outlast the gate around it.
How much does electric gate repair cost in Dallas?
Electric gate repair in Houston, TX runs $260 to $1,400. An opener gear or belt typically lands in the $260-$780 range, while a control board, safety loop, or keypad with wiring diagnostics runs $320-$900. Commercial operators from FAAC, BFT, DoorKing, Elite, and Viking can reach $1,400 on a heavy slide gate. Call for a free estimate – you’ll get the number in writing before we start.
Can you come out the same day?
Often, yes. We answer the phone live 24 hours a day, and same-day appointments are common in Dallas when a gate is stuck open or won’t latch. Call (626) 649-4572 for a free estimate. A live person picks up whenever you call, and you’ll get your written price before anyone starts work. Learn more on our home page, or ask us about the 365-Day Done Right Promise – it covers every repair and installation we do.
Written by Cody Beckman, Owner at Latch & Post Gate Repair, serving Dallas since 2009.
What Our Customers Say
"Electric gate was acting up. He was calm and methodical, found the bad sensor, and tidied the whole area by the gate post when he finished. No grease left on the driveway."
- Ravi Menon"Gate motor died and they replaced it carefully, cleaning every bit of debris off the driveway. Mindful not to leave the yard open with our dog out. Great crew."
- Benson Ide"The gate screeched and dragged. They fixed the track and oiled it, and wiped down everything after so there was no mess. Quiet and kind, in and out without any fuss."
- Opal Reddick