Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Waller, WA
Gate work in Waller runs on farm time, not suburb time. Most properties here are hobby farms, horse parcels, or acreage with long gravel driveways, and the gates on them are built to keep animals in and weather out. The rain-soaked Cascade foothill soil shifts seasonally, which is why a gate that latched fine in August starts dragging by February. We’re Latch & Post Gate Repair, part of the Cedarwell family since 2009, and we handle everything from a leaning post reset to a full electric opener replacement. If your gate isn’t closing right, call (626) 649-4572 and we’ll give you a straight answer.
Why Waller Homes Are Different
Waller sits in the wet foothills east of Tacoma, and that changes how gates fail. The clay-heavy ground holds water through winter, which makes wood posts heave, rot at ground level, and lean out of plumb. Steel hardware rusts faster here than it does in drier parts of Pierce County. A gate that “stopped closing right” in Waller usually traces back to a post that shifted, not a latch that broke. Properties here typically have utilitarian swing or slide gates on wood or steel posts set directly in saturated soil, not decorative iron gates on concrete footings. Many were installed years ago without proper drainage or post depth, and the result is a recurring cycle: post moves, gate drags, hinges bind, something bends or snaps. We see cattle-panel gates with exposed steel hinges on nearly every road in the area. The fix that actually lasts in Waller usually involves resetting the post deeper, adding gravel drainage, and re-hanging the gate so it clears the ground through all four seasons.
Our Main Waller Services
Most calls from Waller homeowners come down to two things: a gate that won’t close properly, or an opener that quit after a wet winter. Here’s what each involves locally.
Gate Repair in Waller
A Waller gate repair almost always starts at the post. We dig out the base, check for rot and saturation, and reset the post in gravel before re-hanging the gate so it swings or slides cleanly. Then we address the hardware: hinges, latches, wheels, whatever actually failed. On farm gates we often replace exposed steel hinges that have rusted through after years of Cascade moisture. The full rundown, including local pricing and what to expect on a service call, is on our Gate Repair in Waller page.
Gate Installation in Waller
New gates in Waller need to clear gravel, handle heavy farm traffic, and stand up to wet ground. We size the gate to the driveway width, set posts deep with proper drainage, and build for the swing or slide pattern your property can actually support. Whether it’s a cattle-panel pasture gate or a steel driveway gate, we quote the whole job in writing before any work starts. Details on materials, timelines, and what a full install includes are on our Gate Installation in Waller page.
Electric Gate Repair in Waller
Electric gate openers in Waller fail most often from water intrusion. Rain gets into the control board, the arm, or the keypad housing, and suddenly the gate won’t respond or moves halfway and stops. We diagnose the opener, check the safety edges and photo eyes, and replace what’s actually dead rather than selling a whole new system. We’re factory-trained on FAAC, BFT, Linear, and Viking, which covers most of the operators running on Waller properties. The full breakdown is on our Electric Gate Repair in Waller page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Waller
We work on FAAC, BFT, Linear, and Viking operators most often in Waller, and we carry common repair parts for these brands so most fixes happen on the first visit. If you’re not sure what’s mounted on your gate post, check our brands page for photos and part numbers.
Pricing for Gate Company in Waller, WA
Waller gate pricing reflects the work involved, not a sales script. Here’s what we typically see in this part of Pierce County:
| Service | Typical range in Waller |
|---|---|
| Gate service call and diagnosis | $95-$155 |
| Gate latch replacement | $120-$240 |
| Gate hinge replacement (pair) | $160-$310 |
| Wood post reset on gravel driveway | $275-$520 |
| Steel post reset with concrete footing | $420-$780 |
| Gate re-hang and alignment | $130-$280 |
| Full gate re-frame (wood) | $380-$750 |
| Chain-link or cattle-panel gate replacement | $250-$480 |
| Electric gate opener diagnosis (labor only) | $125-$210 |
| Control board replacement | $340-$610 |
| Opener arm or actuator replacement | $410-$720 |
| Keypad or safety sensor replacement | $140-$290 |
What pushes a Waller job up is usually the post: saturated clay soil means digging a wider hole, adding gravel drain material, and sometimes going deeper than code minimums to reach stable ground. Rotted post bases and rusted-through hardware add material cost. Whatever the scope, you get a written price before we touch anything, and that number doesn’t change unless we find something and you approve the extra work first.
Neighborhoods We Serve in Waller
Waller is spread out, and we work the whole unincorporated area from Military Road east to the foothills, and from McMillin north toward Edgewood. Long gravel drives and pasture gates are the norm everywhere out here.
- Military Road corridor
- Waller Road and 72nd Street E area
- McMillin
- Foothills east of Orting
- Mountain Highway area
We schedule by honest logistics. If your gate is down and you’re near the middle of a run, we can often be there in 24 to 48 hours. For an emergency, call and the person who answers will tell you the real ETA, because we don’t guess.
Service Area – Cities Near Waller
While our Waller crews focus on Pierce County’s rural east side, we cover the broader Puget Sound region and eastern Washington. You’ll find the same Cedarwell care and pricing promise in Seattle, WA, Spokane, WA, Tacoma, WA, and Vancouver, WA.
Serving Waller, WA - Our Local Coverage Area
We’re based in the Waller area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Waller
We cover the entire Waller unincorporated area and the surrounding rural roads. If you’re on a long gravel drive off Military Road, Waller Road, Mountain Highway, or any of the back parcels toward the foothills, we service that property. Call us and we’ll tell you straight whether your address is in our regular route.
Most gate repairs have no permit requirement in unincorporated Pierce County. New installations may need nothing if they’re simple driveway gates on your own property, but anything near a county road right-of-way can trigger a review. We flag this during the quote, and we don’t start any job without knowing the local rules.
Yes. We ask about your animals and daily routines before we schedule, and we’ll pick a window that works. That’s part of our C.A.R.E. routine: ask before we move anything, respect the family’s quiet hours, and leave the gate area exactly as we found it, with a cleanup photo to prove it.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Waller Customers Say
"New hinges welded on a heavy gate. They laid down protection so no sparks hit the driveway and cleaned every bit after. Respectful of the property and the result is solid."
- Derek Pulanco"Electric gate was acting up. He was calm and methodical, found the bad sensor, and tidied the whole area by the gate post when he finished. No grease left on the driveway."
- Ravi Menon"Gate motor died and they replaced it carefully, cleaning every bit of debris off the driveway. Mindful not to leave the yard open with our dog out. Great crew."
- Benson Ide