Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Electric Gate Repair Across Cloverleaf
When an electric gate stops working in Cloverleaf, the cause is rarely a mystery to us. We’ve spent years tracing failures back to the same two culprits this community shares: floodwater from Greens Bayou and Hunting Bayou, and the expansive Harris County clay that shifts under gate posts through every wet-dry cycle. Our technicians arrive in Cloverleaf knowing to check for water lines on control boards before anything else. If your gate won’t open, drags, or the keypad has gone dark, call (626) 649-4572 and a live person answers, day or night.
Why Latch & Post Gate Repair Is Cloverleaf’s Preferred Electric Gate Repair Company
We’re a Cedarwell-family gate specialist, not a general handyman service. Our whole trade comes down to the two parts every gate depends on: the latch that holds it and the post that carries it. That focus means when a Cloverleaf homeowner calls us about a drowned slide gate operator off Wallisville Road, we’re not learning on the job. We’ve already seen that failure a dozen times this season. Cody Beckman, who leads our team, insists on one rule above all: write the price down before any work begins. No exceptions.
Every visit includes shoe covers and drop cloths before we step inside, plus a photo of the cleanup before we leave. For families in Cloverleaf with kids and dogs, that’s not a nicety; that’s the difference between a repair you recommend and a crew you don’t. We use pet-safe lubricants where there’s a choice, and if nap time matters, we can schedule around it and keep our tools quiet. Calls are answered by a live person around the clock, and our 365-Day Done Right Promise backs every repair and installation.
Gate Access Control in Cloverleaf
Gate Access Control in Cloverleaf usually means retrofitting an older manual or single-button gate with a keypad, remote receiver, or vehicle detection loop so the gate opens only for who you want. Many Cloverleaf lots were built in the 1950s through 1970s, and a lot of the iron driveway gates still standing are original to the property. Adding access control here is less about luxury and more about common sense. You want a gate that opens when you pull up, not one you have to get out and push in the rain.
Keypad and remote upgrades
We install and repair keypads, remote receivers, and control boards for the brands most Cloverleaf families already own. A standard keypad replacement runs $190-$290, and a new single-channel remote with receiver typically comes in between $260 and $410, depending on the operator.
Vehicle detection for driveway gates
For homeowners who want the gate to open automatically, we install loop detectors and photocell sensors that meet UL 325 safety requirements. That work generally starts around $300 and goes up from there based on asphalt cutting and wiring runs.
Commercial Gate Operator in Cloverleaf
A Commercial Gate Operator in Cloverleaf does more work than people expect. This is a dense, working-class community with auto shops, warehousing, and light industrial yards scattered east of Beltway 8, and those gates cycle dozens or hundreds of times a day. A residential opener gets no business being there. We install and service heavy-duty slide and swing operators built for that duty cycle, with soft-start motors, adjustable close times, and reversible edge sensors.
Legacy operator repair and replacement
When a commercial operator from the late 1990s or early 2000s fails, the control board is often obsolete. We’ll check whether we can source the board or rebuild the wiring before recommending replacement. Where the board is gone, a new operator with modern entrapment protection is the honest answer, and we’ll quote that in writing before you decide.
Safety edge and photocell compliance
Commercial gates need working safety edges, photocells, and warning signs. If yours are missing or dead, we can add them without replacing the whole operator. That type of upgrade in Cloverleaf typically runs $350-$600 per gate, parts and labor included.
Trusted Brands We Service in Cloverleaf
Our technicians are factory trained on the names we see every day in Cloverleaf: Linear, Viking, Ghost Controls, and DoorKing among them. We don’t guess at wiring harnesses or dip-switch settings. Because we run so many calls in this area, we keep common boards, receivers, and remote transmitters stocked locally for those brands, which shortens the time between diagnosis and a working gate. No ordering from across the country while your driveway sits open.
Common Electric Gate Repair Problems We See in Cloverleaf Homes
- Drowned slide gate operators. Low-mounted units sit right in the floodplain. After any serious Harris County rain event, standing water kills the control board and motor housing before the gate even thinks about moving.
- Hinge post tilt in expansive clay. The soil under Cloverleaf swells when wet and contracts when dry. Swing gates built on that soil gradually lean, bind, and stop latching without any storm at all.
- Obsolete control boards. Homes built in the 1960s and 1970s often still run original operators. Their boards lack modern entrapment protection, and once they fail, the retrofit-or-replace call is not optional.
- Corroded chain drives and seized hinges. Gulf Coast humidity eats iron year-round. In Cloverleaf, we routinely find chain drives frozen with rust and hinges that have not been lubricated since the gate was installed.
Pricing for Electric Gate Repair in Cloverleaf, TX
Here are real numbers for this market, not vague estimates. A standard gate motor repair in Cloverleaf runs $280-$520. Opener repair typically falls between $240 and $480. Keypad repair lands around $180-$320, and remote control replacement usually runs $60-$140 per remote. Safety sensor repair costs $190-$340, and a control board replacement is the widest range at $300-$700, since some legacy boards are no longer available and require an operator retrofit. Before any work starts, you get the exact number in writing. No work begins until you’ve read it and said yes. Call (626) 649-4572 for a free estimate.
We Also Serve Cities Near Cloverleaf
Our Electric Gate Repair service runs through the surrounding metro, and we coordinate dispatch for Cloverleaf from our Houston office. Beyond Cloverleaf, homeowners call us from Houston, San Antonio, Dallas, and Fort Worth for the same written-price, cleanup-photo standard. If you’re just outside the area, ask when you call; the team works these routes weekly. See our main Electric Gate Repair in Cloverleaf page for the full service list.
Serving Cloverleaf, TX - Our Local Coverage Area
We’re based in the Cloverleaf area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Cloverleaf
If floodwater reached the operator, we check the control board and motor housing first. If the board is corroded and the operator is over 12 to 15 years old, replacement is usually the cheaper long-term answer in Cloverleaf. On a newer unit, a board or motor swap gets you back running. Call (626) 649-4572 and we’ll tell you which one applies before you spend a dollar.
The expansive clay under Cloverleaf heaves with every wet-dry cycle, and that tilts hinge posts out of alignment even in dry weather. The fix is often re-leveling the post footing and re-hanging the gate, not forcing the hinges. We see this on 1960s and 1970s lots all over the area.
Some older operators can be retrofitted with new photocells and safety edges, and we’ll do that where the board supports it. But many 1980s and 1990s boards cannot accept modern entrapment protection. In that case, the honest answer is a new operator, and we’ll quote both options in writing so you can decide with real numbers.
We pull the control board and look for water lines, silt, and corrosion. In Cloverleaf, drowned slide gate operators are so common after Greens Bayou rises that this is our standard first step. If the board is dead, we quote a replacement or a retrofit, and you see the number before we proceed.
Yes. We handle residential ornamental iron driveway gates and apartment or light industrial commercial operators alike. Our Cloverleaf calls mix older single-family gates on 1950s-style lots with warehouse and shop gates near Beltway 8. Call (626) 649-4572 and tell us what you have; estimates are free and the price is written before work starts.
When your gate stops working in Cloverleaf, call (626) 649-4572. A live person answers, we dispatch from our Houston office, and you get a written price before any tool leaves the truck. Whether it’s a drowned operator off Wallisville Road or a hinge post that’s been drifting for years, we’ll walk you through the repair and leave your floors clean when we’re done.
Written by Cody Beckman, Owner at Latch & Post Gate Repair, serving Cloverleaf through the Cedarwell family since 2009.