Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Daly City, CA
Daly City gates fail differently than gates almost anywhere else in the Bay Area. The salt-laden fog that rolls in off the Pacific settles into every hinge, latch, and weld, and the postwar Doelger tract homes that fill Westlake and St. Francis were built with narrow side yards and original hardware from the 1950s and 60s. That combination means most of the work here is rehabilitation: freeing corroded cast-iron hinges, replacing seized slide bolts, and realigning wood gates that have swollen out of square. If your gate sticks, sags, or won’t latch, call us at (626) 649-4572 and we’ll send a technician who knows exactly what Daly City weather does to a gate.
Why Daly City Homes Are Different
Henry Doelger’s stucco row homes define the housing stock here, and they were built on lots measured in feet, not acres. The typical side-access gate on a Westlake or Broadmoor block is 3 to 4 feet wide, flanked by a stucco wall on one side and the house on the other. That compressed footprint leaves almost no room to work, and the original hardware was light residential spec: cast-iron hinges and basic slide bolts that were never meant to survive sixty years of marine-layer exposure. Fog is not a seasonal visitor in Daly City. It sits over these neighborhoods for most of the year, carrying salt from the Pacific a few miles west. Bare steel and iron oxidize fast. We routinely find hinges so thoroughly corroded that unthreading the screws is impossible; the only practical move is drilling them out and setting new hardware. Wood gates swell with the moisture, delaminate at the corners, and pull away from their latches. When a Daly City homeowner tells us the gate “suddenly” stopped closing, it’s rarely sudden. It’s the end of a long rust-and-swelling process.
Our Main Daly City Services
Most calls in Daly City fall into three buckets: bringing a tired side gate back to smooth operation, replacing one that has reached the end of its life, or diagnosing an electric gate opener that has stopped responding to the remote or keypad.
Gate Repair in Daly City
Gate repair in Daly City usually starts with the hardware, not the wood. We remove corroded hinges and latches, drill out seized fasteners, and set new galvanized or stainless hardware that holds up better against salt fog. Where the wood post has rotted at ground level, we dig and set a new pressure-treated post in concrete, then re-hang the gate so it clears the ground and latches without lifting. Most side-yard repairs on a Doelger-era lot run a half day start to finish, and the written price is in your hand before any work begins. Full details are on our Gate Repair in Daly City page.
Gate Installation in Daly City
A new gate in Daly City has to fit a tight space. The 36-inch side-yard clearances common in Westlake and Serramonte mean we build to measure rather than pulling a stock panel off a truck. We work in cedar and redwood for wood gates, both of which stand up to coastal moisture better than fir, and we set posts deep enough that swelling soil from winter rain doesn’t heave them. Your floors stay clean: shoe covers on, drop cloths down, and a photo of the clean-up before we leave. Measurements and a written price are free. See Gate Installation in Daly City for what to expect.
Electric Gate Repair in Daly City
Electric gate systems in Daly City are mostly on newer properties and small commercial lots around Serramonte, or on homes where an automatic opener was added to a driveway gate. The marine layer is hard on control boards, limit switches, and exposed wiring connections; corrosion at a terminal block is the single most common fault we trace. We’re factory-trained on FAAC, BFT, Linear, and Viking operators, and we carry the seals, remotes, and edge sensors that keep a salt-air system running. Anything involving line voltage or a gate under spring tension needs a trained hand. Details at Electric Gate Repair in Daly City.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Daly City
We service and install FAAC, BFT, Linear, and Viking gate operators, plus the LiftMaster, Ghost Controls, DoorKing, Elite, and Mighty Mule units already on Daly City properties. Common boards, remotes, and safety edges are stocked in our Bay Area warehouse so we’re not waiting on a part shipment to finish a repair. See our brands for the full list.
Pricing for Gate Company in Daly City, CA
| Service | Typical range in Daly City |
|---|---|
| Gate hinge replacement (pair) | $140 – $320 |
| Gate latch replacement (basic slide bolt) | $90 – $210 |
| Strike plate replacement and realignment | $80 – $180 |
| Post replacement (wood, dug and set in concrete) | $340 – $700 |
| Gate straightening and re-hang | $180 – $420 |
| Full side-gate installation (3-4 ft, standard hardware) | $850 – $1,900 |
| Electric gate opener diagnostic | $120 – $240 |
| Control board replacement | $280 – $620 |
| Operator arm replacement | $300 – $650 |
| Photoelectric sensor or safety edge replacement | $160 – $380 |
In Daly City, the biggest price movers are access: a gate squeezed into a 4-inch side-yard gap between a stucco wall and a fence takes longer to work on than one with room to stand, and post replacement costs more when the old concrete footing has to be jackhammered out. Seized cast-iron hardware that needs drilling also adds labor time. Whatever the job, you receive a written price before any work starts, and that number doesn’t move unless you approve a change in scope.
Neighborhoods We Serve in Daly City
We work across the whole city, including the Doelger-era blocks and the mid-century homes that make up most of the housing stock. Typical response time for a Daly City call is same-day or next-morning.
- Westlake
- St. Francis Heights
- Broadmoor
- Serramonte
- Southern Hills
Service Area – Cities Near Daly City
Our Daly City crews also cover the neighboring communities along the San Mateo County line and the coast. If you’re in Brisbane, CA, South San Francisco, CA, San Bruno, CA, or Pacifica, CA, give us a call and we’ll route the nearest technician to you.
Serving Daly City, CA - Our Local Coverage Area
We’re based in the Daly City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Daly City
Same-day in most cases, and next-morning at the latest. Daly City is a compact city with direct freeway access, so our Bay Area-based dispatch can usually have a technician to a Westlake or Serramonte home within a few hours of your call. Call (626) 649-4572 and we’ll tell you exactly when we can be there.
For a straight replacement of an existing side gate with the same dimensions, no permit is typically required. If the project changes the fence height, adds a driveway gate, or involves new electrical for an opener, permit requirements may apply. We can tell you what applies to your specific street before we start.
Yes. We schedule specific time windows, and we’ll work quietly: battery tools instead of air hammers where possible, no loud equipment near bedroom walls, and we’ll coordinate with you on when the dog is inside or the kids are up. Tell us what works for your household and we’ll plan around it.
If your gate has started scraping, sticking, or refusing to latch, call (626) 649-4572 for a free estimate. A live person answers around the clock, and you’ll get a written price before any work begins.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Daly City Customers Say
"Our gate opener quit and they came out quick. The tech was careful not to leave the yard open while our dog was out, which I really appreciated. Clean work, swept up the metal shavings."
- Eleanor Boggs"New hinges welded on a heavy gate. They laid down protection so no sparks hit the driveway and cleaned every bit after. Respectful of the property and the result is solid."
- Derek Pulanco"Electric gate was acting up. He was calm and methodical, found the bad sensor, and tidied the whole area by the gate post when he finished. No grease left on the driveway."
- Ravi Menon