Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Whittier
Gate repair in Whittier usually costs between $180 and $480 for most hinge, latch, and alignment work, and a full operator replacement on a sloped Friendly Hills driveway typically runs $900 to $1,800. We’re Latch & Post Gate Repair, part of the Cedarwell family, and we’ve worked on gates across Whittier long enough to know that this city’s gate problems don’t look like the ones in Norwalk or Pico Rivera. The Whittier Narrows fault has been quietly shifting the ground under this city since 1987, and your gate posts feel it. Call (626) 649-4572 any hour, and a live person answers, not a queue.
Why Latch & Post Gate Repair Is Whittier’s Preferred Gate Repair Company
Cody Beckman, our owner, built Latch & Post around a simple idea: every gate comes down to two parts, the latch that holds it and the post that carries it. That’s the job we focus on. We’re not a general handyman service. We repair gates, install gates, and fix electric gate operators, and that’s the whole list. Whittier homeowners call us because we show up in uniform, lay drop cloths on the floor, put on shoe covers before stepping inside, and hand you a written price before any work begins. Then we take a photo of the clean-up before we leave.
Every call is answered by a live person, 24 hours a day, seven days a week. Dispatch and scheduling are coordinated from our Los Angeles office, but our crews are local and know Whittier’s streets, from the older flatland tracts near uptown to the long sloped driveways in Friendly Hills. The 365-Day Done Right Promise covers every repair and installation: if it’s not right, we make it right. No argument, no fine print.
Our Gate Repair technicians see the same local failure modes over and over: hinge posts that have drifted out of plumb from seismic settlement, operators that were never sized for a 7% grade, and gates hung before UL 325 entrapment protection existed. That local knowledge means the right fix happens on the first visit, not the third.
Wrought Iron Gate Repair in Whittier
Wrought iron gate repair in Whittier often means something different than it does in a flat city ten miles south. Your iron gate might be bent, sagging, or refusing to latch because the post underneath it has been heaving and tilting for decades on Whittier Narrows soil. We don’t just bend the latch to meet; we check the post footing, re-set it if it’s drifted, and re-align the frame so the gate actually works like a gate again. Standard wrought iron repairs in Whittier run $200 to $420, including hinge replacement and frame realignment.
Post Re-Set and Frame Alignment
On a 1950s flatland tract near uptown, we found a tubular steel side-yard gate whose concrete post had heaved after decades of seismic micro-settling. The latch no longer met, and the homeowner had been leaning hard on the gate for months just to close it. We re-set the post, corrected the sag at the hinge, and re-aligned the frame rather than just bending the latch. The price was written before we started, and the clean-up photo went to the owner before the truck left.
Hinge Repair and Welding
Whittier’s Santa Ana winds push hard on single-latch swing gates, especially older iron ones with thin hinge leaves. We straighten, shim, or replace hinges as the frame allows, and we weld cracked joints back to clean metal before repainting the repair area. Quiet tools and pet-safe materials are standard on every visit, which matters when kids and dogs are near the gate.
Metal Gate Repair in Whittier
Metal gate repair in Whittier covers tubular steel, aluminum, and heavier welded steel gates, and the most common job is fixing a sag that gets worse every season. The gate itself might be fine; the problem is usually a post footing that’s cracked or drifted on the city’s older flatland slabs, or hinges that have worn asymmetrically because the frame is no longer square. Typical metal gate repairs in Whittier run $180 to $460 depending on whether we’re replacing hinges, re-setting a post, or cutting out and rebuilding a rusted section.
Hinge Replacement and Face-Mount Retrofit
Older Whittier homes from the 1940s and 1950s frequently have gates retrofitted decades after the house was built, often with shallow post footings that have shifted. Our technicians remove the old hinges, grind the post face clean, and set new face-mount hardware that holds alignment. We explain why the original hardware failed before we replace it, so you’re not paying for the same repair twice.
Frame Straightening and Rust Work
Low humidity during Santa Ana events strips moisture from painted steel, and once the coating cracks, rust follows. We cut out the corroded section, weld in clean metal, and add a protective coat so the repaired area matches the rest of the gate. We can schedule quieter work around nap time if that matters in your house.
Trusted Brands We Service in Whittier
We’re factory-trained on the operators Whittier homeowners actually have on their driveways: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. That matters in Friendly Hills, where a FAAC or BFT swing operator on a 6% grade needs different board settings than the same unit in a flat Pico Rivera cul-de-sac. We stock common boards, arms, and safety-edge parts in our service vans, which means faster first-visit fixes for Whittier customers. When a control board fails on an older unit, we tell you honestly whether a repair or replacement is the cheaper path.
Common Gate Repair Problems We See in Whittier Homes
- Post heave from Whittier Narrows settlement – Hinge posts set in older flatland concrete slabs drift out of plumb over decades, so the gate sags, the latch misses, and tightening the hardware only buys a few weeks. The fix is re-setting the footing, not cranking the hinge bolts.
- Gravity-creep on sloped Friendly Hills driveways – Swing gates on 5 to 10 percent grades drift open under their own weight when the operator is worn or underspec’d. It gets misdiagnosed as an electrical fault, but the real problem is mechanical.
- Santa Ana wind stress on swing gates – Single-latch gates act like sails in the wind funnel through the Whittier Narrows, bending hinge leaves and warping frames seasonally. Older gates hung before modern entrapment protection are especially vulnerable.
- Obsolete control boards on legacy operators – Many Whittier homes still run operators installed 15 or 20 years ago, and the boards eventually fail. Sometimes the board can be replaced; other times the whole operator costs less than another temporary fix.
Pricing for Gate Repair in Whittier, CA
Here’s what you can expect to pay in Whittier for the work we handle most. A standard latch replacement runs $120 to $220. Hinge repair or replacement runs $180 to $360 depending on the gate weight and how many hinges. Re-setting a heaved post footings costs $300 to $600, and a full operator replacement on a sloped driveway runs $900 to $1,800 installed. Full gate realignment, including frame and post correction, runs $250 to $450. Every price is written out for you before work begins, so there’s no invoice bigger than the quote. Call (626) 649-4572 for a free estimate.
We Also Serve Cities Near Whittier
Our Gate Repair in Whittier crews regularly work in Pico Rivera, South El Monte, Hacienda Heights, and Montebello. If you’re in one of those neighborhoods and your gate is sagging, drifting, or refusing to close, the same written-pricing and clean-up routine applies. Call us and a live person answers, day or night.
Serving Whittier, CA - Our Local Coverage Area
We’re based in the Whittier area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Whittier
The hinges aren’t the root problem; the post footing is. Whittier sits directly on the fault zone that produced the 1987 Whittier Narrows earthquake, and decades of micro-settling have heaved and tilted post footings in concrete slabs across the older flatland tracts. Tightening the hinge bolts on a drifted post only strains the hardware more. The lasting fix is re-setting the post and re-aligning the frame. Call (626) 649-4572 and we’ll take a look, with a written price before any work starts.
Possibly, but gravity is usually the real culprit. Friendly Hills driveways commonly run at 5 to 10 percent grades, and a swing gate on that slope wants to drift downhill. If the operator is worn or underspec’d, it can’t hold the gate against the grade. That’s a mechanical issue, not an electrical one, and it’s the first thing we check. We repair or replace the operator and correct any hinge-post tilt so the gate holds closed on its own.
Yes, if the gate is motorized. UL 325 entrapment protection has been code for automatic gates for years, and many older Whittier gates were hung before the standard existed or have operators whose safety edges stopped working. We can retrofit photo eyes, contact edges, and proper warning signage on an existing gate. It’s a straightforward upgrade, and we’ll explain what’s actually required versus what’s optional.
Yes. A cracked post footing is repairable in most cases. We break out the cracked concrete, re-set the post plumb in a new footing, and re-align the gate frame. That sequence fixes the cause, not just the symptom. If the post itself is structurally compromised, we’ll tell you honestly and give you a written price for replacement before we touch anything.
They can, especially on single-latch swing gates that face an open side or sit in a wind channel near the Narrows. High lateral force bends hinge leaves and warps the frame over repeated wind events. Older iron gates are most exposed. If you see fresh scrape marks, a sag that appears seasonally, or a gate that’s harder to close after a wind event, call us at (626) 649-4572. We’ll inspect the hardware and frame and give you a written price before any work starts.
Contact Latch & Post Gate Repair in Whittier
If your gate is sagging, drifting, or refusing to latch, call (626) 649-4572. We’ll answer live, schedule a visit, and hand you a written price before work begins. Our technicians wear shoe covers, lay drop cloths, and photograph the clean-up before they leave. The 365-Day Done Right Promise covers every repair and installation, and the C.A.R.E. values are how we work: Clean up like it’s our own home, Ask before we move or touch anything, Respect your family’s time and quiet hours, and Explain the price before the work.
Written by Cody Beckman, Owner at Latch & Post Gate Repair, serving Whittier since 2009.