Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Electric Gate Repair Across Union Park
If your electric gate in Union Park won’t open, won’t close, or moves halfway and stops, the problem usually comes down to one of two things: the operator motor or the buried loop detector in the asphalt apron. We see it nearly every week in Union Park’s manufactured-home communities and 1980s-built apartment complexes, where communal gates handle dozens of households a day and original equipment from that era has simply run its course. Our Union Park calls typically start with a dead control board from a lightning strike and end with a mechanical repair too, because the humidity here rusts steel while the storms fry electronics. Call (626) 649-4572 and a live person answers, day or night.
Key Takeaways
- Union Park gate calls often begin with a broken buried loop detector, not a dead operator. We test the loop first.
- Central Florida’s June through September storms fry control boards; high humidity rusts hinges, tracks, and rack gears at the same time.
- Most electric gate repairs in Union Park run between $180 and $480 for board replacements, loop detector repair, sensor fixes, and hinge-post corrections. You’ll see the exact number in writing before we start.
- We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule equipment.
- Every repair is covered by the 365-Day Done Right Promise. If it isn’t right, we make it right.
Why Latch & Post Gate Repair Is Union Park’s Preferred Electric Gate Repair Company
We’ve worked enough gates along Aloma Avenue, in the communities off Goldenrod Road, and throughout the manufactured-home parks between Lake Underhill and East Colonial to know that Union Park’s gates fail differently than the ornamental iron driveway gates you’ll find a few miles east near Waterford Lakes. Those are newer and lightly used. Yours probably cycles thirty or forty times a day carrying every resident in and out. That’s a different failure profile and it takes a local technician who has seen it to diagnose it right the first time.
We’re part of the Cedarwell family and have been doing this work since 2009. Cody Beckman leads our gate repair team, and he insists on something most gate companies never mention: a written price before any work begins, shoe covers and drop cloths on every visit, and a photo of the cleanup before we leave. That’s the Cedarwell Care Promise and it’s not an upsell. It’s how we’ve always worked.
Union Park customers call us back because we answer the phone. Not a voicemail queue, not a callback request. A live person answers 24/7, including holidays and the middle of a summer thunderstorm when your gate just died and you can’t get your car in. That matters here, where a communal gate outage affects every household in the park, not just one driveway. Scheduling and dispatch are coordinated from our Miami office, and crews serve Union Park locally.
Electric Gate Motor in Union Park
Electric gate motor repair in Union Park usually means one of two jobs on a communal entry gate: replacing a swing-arm operator that’s been cycling dozens of times a day since the 1980s, or rebuilding a slide-gate motor whose rack and pinion have rusted in the humidity. The operator is the muscle. When it fails, the gate won’t move, or it moves with a grinding sound, or it opens but won’t reverse. On most Union Park calls the operator isn’t actually dead. Something upstream of it is wrong and the board shut the motor down to protect itself. We diagnose that before we sell you a motor.
Swing arm operators on communal drives
Original swing-gate operators on shared entries wear out hinge posts, cause panels to sag, and fail safety photocells from years of deferred maintenance. A typical swing-arm operator replacement in Union Park runs $650 to $1,400 depending on access and whether the hinge post needs correcting at the same time. We correct the post when it’s needed rather than leaving it to sag again in six months. That’s the difference between a repair and a comeback.
Slide gate motors and rusted rack gears
Slide gates here hold morning dew on the east-facing side, and that rusts the rack and pinion. When the rack is chewed, a new motor will still grind and stall, so we inspect the rack before we quote the motor. Slide operator replacement in Union Park typically runs $800 to $1,600 including rack correction where needed.
Gate Access Control in Union Park
Gate access control in Union Park is about replacing what no longer talks to the gate: obsolete magnetic-card readers, keypads with worn buttons, and phone-entry systems that haven’t worked reliably since the complex was new. Many communities here installed card, keypad, or mag-stripe entry systems in the late 1980s and early 1990s, and simply kept them past their useful life. The gate operator may be fine. The access system is the problem. We replace keypads, card readers, remotes, and the control boards that tie them all together. We don’t ask you to rip out a working operator just to modernize access.
Keypads and phone entry on older communal gates
We replace worn keypads and weather-damaged entry panels on apartment and manufactured-home community gates throughout Union Park. A basic keypad or card-reader replacement runs $220 to $450 installed, and if your existing operator can speak to a modern access system, we keep it in place. When it can’t, we’ll tell you that plainly and quote a control board upgrade instead.
Upgrading old loop detectors and safety edges
Every gate access system needs two safety layers: a vehicle-detection loop in the ground and photo-eyes or a safety edge on the gate itself. On Union Park’s older entries, the loop is often damaged under years of re-paved asphalt and the photoelectric sensors are faded or misaligned. Loop detector replacement and repair runs $250 to $550 depending on whether we’re splicing a broken wire or saw-cutting and installing a new loop. Safety sensor replacement runs $180 to $320 per pair.
Trusted Brands We Service in Union Park
Most Union Park gates we see run LiftMaster, DoorKing, or Viking equipment, and our technicians are factory-trained on all three plus FAAC, BFT, Linear, Ghost Controls, Elite, and Mighty Mule. We keep common boards, loop detectors, remotes, and safety edges in local stock so a standard repair doesn’t wait on a week-long part shipment. If your community gate runs on original DoorKing equipment from the 1990s, we can almost always match it. If it runs on a brand we don’t service, we’ll tell you that before we step foot on the property. No guessing, no experiments.
Common Electric Gate Repair Problems We See in Union Park Homes
- A gate that opens but won’t close because the loop detector is dead. The operator thinks a car is still sitting on the loop, so it refuses to close. The original loop wiring under the asphalt apron has been re-paved over three times and finally severed. We test the loop before we ever touch the motor.
- A control board that fried during a summer thunderstorm. Near-daily lightning from June through September sends surges into gate boards all over Union Park. The operator sounds dead but the board is the actual casualty. We replace the board and add surge protection when the panel allows.
- Rusted steel on east-facing gates. Morning dew hangs longest on the east side of every gate in Union Park. Hinge posts rust, panels sag, and slide-gate racks pit. We correct the rusted post or rack during the same visit as the electrical repair.
- Worn keypads and card readers that stop recognizing residents. The operator is fine. The access panel buttons are worn smooth and the card reader’s weatherproofing has failed. We replace the access component and keep the working gate equipment.
Pricing for Electric Gate Repair in Union Park, FL
Here’s what to expect in Union Park specifically. Our service call to diagnose a gate problem runs $95, and that’s it, no hidden dispatch fee. Control board replacement runs $280 to $480 on most LiftMaster, DoorKing, and Viking models. Loop detector repair runs $250 to $550. Keypad or card reader replacement runs $220 to $450. Swing-arm operator replacement runs $650 to $1,400, and slide-gate operator replacement runs $800 to $1,600 including rack correction. These are the numbers we quote in Union Park, and you’ll see your exact price in writing before we touch anything. Call (626) 649-4572 for a free estimate, no obligation to accept. We also provide a written price before any work begins on every visit, no exceptions.
We Also Serve Cities Near Union Park
Our Electric Gate Repair team covers Union Park and surrounding Orange County communities. If your property is in Union Park proper or just outside it, we’ll come out. We also serve Jacksonville, Miami, Tampa, and Orlando, so if your community has gates in multiple locations, one phone call can schedule them all. Call (626) 649-4572 and a live person will sort out the schedule.
Serving Union Park, FL - Our Local Coverage Area
We’re based in the Union Park area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Union Park
The fastest test is the same one we run first: check whether the gate moves at all, even an inch. If it moves and then reverses or refuses to close, the loop detector is usually the culprit. If it doesn’t move at all and there’s no hum from the operator, the board or the power supply has likely failed. On Union Park’s re-paved communal entries, the buried loop from the 1980s or 90s has often been severed by re-paving, so the gate behaves as if a car is always present. We test the loop before we condemn any motor. If it’s the loop, replacing a motor would have been a waste of your money. Call (626) 649-4572 for an exact diagnosis.
Yes. We repair solar-powered gate openers for long driveways where running mains power is impractical, which includes several acreage and manufactured-home properties on the edges of Union Park. We service the solar charge controller, battery bank, and the operator itself. A solar gate opener battery replacement typically runs $120 to $200, and a charge controller replacement runs $180 to $350. The issue on most solar gates in this area is not the sun; it’s corrosion on the battery terminals. Call (626) 649-4572 and we’ll diagnose it.
Because Union Park sits in Central Florida’s near-daily summer thunderstorm zone, and the power surge from a close lightning strike enters through the gate’s low-voltage wiring and fries the microprocessor on the control board. Replacing the board without adding surge suppression means it will fail again in the next heavy storm. We carry surge protectors designed for gate panels and install them during the same visit, so the new board isn’t a lightning target. Board replacement for most brands runs $280 to $480 including the surge protector.
On a swing gate in Union Park, sag and drag usually mean a rusted hinge post, not a weak operator. East-facing gates hold morning dew longest, and that rust works on the steel post until the panel tilts. The operator then has to push against gravity as well as the gate’s weight, and motors burn out sooner. We correct the hinge post when we replace the motor, which is why our operator quotes include checking the post. Hinge post correction alone runs $180 to $350 depending on the amount of sag. Call (626) 649-4572 and we’ll assess the whole gate, not just the motor.
Yes, and it’s one of the most common jobs we do in Union Park. Many communities still run original 1980s and 90s mag-card or keypad systems. We replace the keypad or card reader and, when the operator can’t support a modern access system, we upgrade the control board as well. A keypad or card reader replacement runs $220 to $450, and a control board upgrade runs $280 to $480. You don’t have to replace the whole gate. Call (626) 649-4572 for a written quote and we’ll tell you what your existing operator can support.
Call Latch & Post Gate Repair in Union Park
If your electric gate in Union Park won’t open, won’t close, or reverses on its own, call (626) 649-4572. A live person answers any time, day or night, and we’ll schedule a technician to come out, diagnose the problem, and give you a written price before any work starts. We’ll lay drop cloths and wear shoe covers if we need to come inside your home. We’ll show you a photo of the cleanup before we leave. And every repair is covered by the 365-Day Done Right Promise. Because every gate comes down to two parts: the latch that holds it and the post that carries it. That’s the job we focus on.
Written by Cody Beckman, Owner at Latch & Post Gate Repair, serving Union Park since 2009.